Go to Control Panel / External Access / QuickConnect. If the drive receives a Failing test result, it is likely to be defective and needs to be replaced.STEP 2. For detailed steps, refer to the respective help article for DSM 7 and DSM 6.2. 4 5.Resolution Run an extended S.M.A.R.T. In the pop-up window, fill in the fields accordingly, and then click Create to finish. Under the Port Forwarding tab, click Create. Go to SRM > Network Center > Port Forwarding. Now you're ready to enjoy your music collections from Synology Audio Station with Amazon Alexa.Set up port forwarding rules on SRM. Enter the corresponding address of your Synology NAS 3, and specify the port number if other than 443. Tap or click on Enable for Audio Station to start the account linking. ![]() I also can't connect to the IP (either the 169.xxx or the 192.xxx that the wizard tried to apply) via a browser.Go to Skills section, and search for Audio Station. I'm assuming this is the correct port if I haven't changed the default DSM ports? When I try to continue, it says it failed to apply the settings, and it reflects the "connection failed" status in the Synology Assitant. Corresponding hostname in Audio Station is set to. Please check the Internet connectivity, and ensure normal access to your DiskStation from the Internet. If the problem persists, please contact Synology Technical Support. Please restart UPnP/NatPmP protocol on the router or restart the router. Port forwarding rules could not be reapplied. Select whether to use minimalist tray icon.Due to changes in default gateway settings, the feature of port forwarding rules has been enabled. Under the Display tab, you can modify the below options: Select whether to show tutorial tips the next time Synology Drive Client is launched. ![]() To edit display settings: Double-click on the Synology Drive Client icon in the system tray and go to Global Settings. The only thing I needed to do was to add the same port forwards manually on the. And the ones that was allready set previously when it was working was now gone from the router (but still visible in the router config page on the NAS). Responses (1-2) Sorted by R Razmahwata I found a solution now! For some reason, the NAS wasn't able to set port forwarding on the router anymore. When I go into Storage Pool and select Remove I get "failed to apply settings". I need to remove the storage pool and recreate it so that I can incorperate larger discs. This was a mistake as the 918+ will now only support 16TB of disc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |